So last night, I was looking at the instructions to flash to shibbys tomato for the r6250. Router was running dd-wrt before the brick. After flash the initial file, the router boots and shows the netgear logo and green on light. But I cannot access the GUI.
I have used two different computers to recover bit no luck. It will ping during boot but tftp2 cannot push another firmware to it. It will not pick it up It up at all. I tried serial, but I do not think it was working properly since...
r6250 bricked after flashing initial flash tomato shibby
I have used two different computers to recover bit no luck. It will ping during boot but tftp2 cannot push another firmware to it. It will not pick it up It up at all. I tried serial, but I do not think it was working properly since...
r6250 bricked after flashing initial flash tomato shibby