I have native ipv6 from my ISP delivered via Ethernet. I am using Version 1.28 by shibby on a linksys WRT54GL.
I am assigned a /48, and my ipv6 is routed to me via a different point-to-point link, which is a /64, but only using the first 2 addresses in the assignment.
When my router originates traffic, it is sent out with the source address of my point-to-point link, and not the ipv6 address assigned to the router. I used to have this issue also with my Hurricane Electric tunnel, which also...
ip addr change does not work, need to set perferred_lft
I am assigned a /48, and my ipv6 is routed to me via a different point-to-point link, which is a /64, but only using the first 2 addresses in the assignment.
When my router originates traffic, it is sent out with the source address of my point-to-point link, and not the ipv6 address assigned to the router. I used to have this issue also with my Hurricane Electric tunnel, which also...
ip addr change does not work, need to set perferred_lft