I have two questions here:
1) On Netgear 3500L port status doesn't work properly. The device thinks (overview page) that the WAN port is port 1 where port 1 is port 2.
I did try to set the reverse order but no luck it's just not correct, also the WAN port is always on even if no devices are connected as far as I can see. it seems like a little bug perhaps specific of this device. On this device I'm running the version 117 of Shibby MIPS2 2.6 VPN.
Shibby keep in touch if you need additional...
About shibby and VLANs on Netgear 3500L
1) On Netgear 3500L port status doesn't work properly. The device thinks (overview page) that the WAN port is port 1 where port 1 is port 2.
I did try to set the reverse order but no luck it's just not correct, also the WAN port is always on even if no devices are connected as far as I can see. it seems like a little bug perhaps specific of this device. On this device I'm running the version 117 of Shibby MIPS2 2.6 VPN.
Shibby keep in touch if you need additional...
About shibby and VLANs on Netgear 3500L